Adding and updating gateways

You can configure the MCU with one or more H.323 gateways:

To add an H.323 gateway, go to Gateways > Add new H.323 gateway. After entering the settings described below, click Add H.323 gateway.
To update an existing H.323 gateway, go to Gateways and click on a gateway name. After updating the settings described below, click Update H.323 gateway.

Field	Field description	More information
Name	The descriptive name of the gateway.	All gateways must have a unique name.
Address	The IP address or host name of the gateway.	Note that square brackets are mandatory for IPv6 addresses.
Motion / sharpness trade off	Choose whether to use the unit-wide/blade-wide setting for motion/sharpness trade off, or configure an individual setting for this gateway. Choose from: Use box-wide setting: this is the default value. In this case, connections to the gateway will use the motion/sharpness tradeoff setting from the Settings > Connections page Favor motion: the MCU will try and use a high frame rate. That is, the MCU will strongly favor a resolution of at least 25 frames per second Favor sharpness: the MCU will use the highest resolution that is appropriate for what is being viewed Balanced: the MCU will select settings that balance resolution and frame rate (where the frame rate will not be less than 12 frames per second)	The settings for motion (frames per second) and sharpness (frame size or resolution) are negotiated between the endpoint and the MCU. This setting controls how the MCU will negotiate the settings to be used with this endpoint.
Preferred bandwidth from MCU	The network capacity (measured in bits per second) used by the media channels established by the MCU to a single participant.
Preferred bandwidth to MCU	Sets the bandwidth that the endpoint will advertise to the MCU when it calls it.

	MCU 4520
	主機: FETMCU03